877.777.0655

ReportsNow.com

 

WEBCASTS

     
 

March 12, 2009

 
 

Save BIG on BI

 
     
 

UPCOMING EVENTS

     
 

COLLABORATE 09

Booth: 5575

 
 

May 3 - 7, 2009
Orange County Convention Center
Orlando, FL

 
     
 

Workstation Install Procedure

Perform this installation if you use E1 in the full client mode -- i.e. you have a full E1 client install on your workstation.

  • If you do not have a drive mapped to your deployment server share, map a drive to the <Dep Server Name>\B7333
  • From your mapped drive, run: <Dep Server Name>\B7333\Data Access Studio\Setup.exe
  • If you do not have the .NET framework on your workstation, the setup program will launch the .NET installer.  When prompted to do so, install the .NET framework to your workstation.  This installation takes about 5 minutes.  You only need to install the .NET Framework once.
  • Once the .NET pre-requisite is installed, setup presents the installer welcome screen:
  • Click "Next".

  • Pick the default location that the Installer provides.  Select the "Everyone" radio button.  Click "Next".
  • Click "Next" again to begin the installation.
  • Once the installation is complete, press "Close".
  • If the machine's MDAC level is below 2.8, setup.exe will invoke the MDAC installer.  This install is optional unless you intend to use the OLE DB features of DAS.  If you perform the MDAC install, then you will be required to reboot this machine.  To cancel the MDAC install, press Cancel.  Otherwise install the updated MDAC drivers.
  • To run DAS, simply click the DataAccessStudio icon that was installed to your desktop.  Alternately, run DataAccessStudio.exe from the folder where you installed Data Access Studio above.  Or, refer to the DAS Helps to see how to setup DataAccessStudio as a Task/Shortcut in EnterpriseOne.

Back to Install Instructions

 
 
 
 

Questions or problems regarding this web site should be directed to support@reportsnow.com
Copyright © 2003 Dominion Software . All rights reserved.
Last modified: 02/26/09.